Shorelandr 3 NB Swing Tongue Manual do Utilizador descarregar pdf

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003846

Page 1 08/16/07

ACCESSORY

3” Swing Tongue Assemblies for

Non-Brake Trailers

The 3” non-brake swing tongue assembly is a replacement tongue that can be installed in any 2x3 trailer frame that is not equipped with

a brake system. It will replace a standard tongue and allows the front 30” section of the tongue (including the coupler) to be swung to the

side so that it will t in a shorter storage area.

The winch post assembly must never be attached to the swing section of the tongue. The tongues are available in two different length

rear sections to accommodate the mounting of the winch post. Choose the correct length that best adapts to the winch post setting for

your boat.

Removing the Old Tongue from the Frame

• Remove the boat from the trailer.

• Measure the location of the winch post with respect to the frame

tongue channel before removing it so you know where it needs

to be re-installed on the new tongue. Remove the winch post

assembly by removing the three-3/8” x 4” hex bolts.

• Remove the coupler from the front of the old tongue.

• Remove the safety chains by removing the bolts that attach

them to the old tongue.

• Remove the ½” x 1 ½” hex bolt holding the tongue cap and the

rear of the tongue into the tongue channel.

• Remove the ½” x 4” hex cross bolt that attaches the tongue in

the front of the tongue channel.

• Disconnect the side frame wire harnesses from the tongue har-

ness. Remove the tongue harness.

• Remove the old tongue assembly from the frame.

Installing the New Swing Tongue to the Frame

• Locate the new swing tongue and slide the rear section into the

frame tongue channel.

• Align the cross hole in the new tongue with the hole in the

frame tongue channel. Insert the ½” x 4” cross bolt just removed

through the aligned hole to secure it in position. Place on the

ange lock nut. DO NOT tighten at this point.

• Route the tongue wire harness just removed down through the

hole in the top of the tongue, then backwards to the swing end.

1 2

Page 2 08/16/07 2

Resumo do Conteúdo

Página 1

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003846Page 1 08/16/07ACCESSORY3” Swing Tongue Assemblies f

Página 2 - Page 2 08/16/07

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003846Page 2 08/16/07• Route the wires through the bottom

Modelos relacionados 5 NB Swing Tongue

Comentários a estes Manuais

Sem comentários

Shorelandr 3 NB Swing Tongue Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Reboques Shorelandr 3 NB Swing Tongue. ShoreLand'r 3 NB Swing Tongue User Manual Manual do Utilizador

Resumo do Conteúdo

Modelos relacionados 5 NB Swing Tongue

Comentários a estes Manuais

Manuais e produtos relacionados com Reboques Shorelandr 3 NB Swing Tongue